How to Reset Your Ring Doorbell: A Step-by-Step Guide

To perform a hard reset, hold down the orange button for 20 seconds . After releasing it, the light on the front will flash a few times indicating that your Ring Doorbell is restarting. It may take a minute to fully complete this process.

If you’re planning on selling your Ring Doorbell or experiencing some issues with it, you might want to consider resetting it back to its factory default settings. Fortunately, resetting your device is simple and can be done in just a few steps. In this post, we will guide you through the process of resetting your Ring Doorbell.

To begin, you will need a Torx bit screwdriver, which usually comes with your Ring Doorbell. If you don’t have one, you can use a T15 bit instead. Start by unscrewing the device from the mounting bracket, but you don’t have to remove the screws completely. Just go a little way and then push up on the doorbell to release it from the bracket.

Next, turn the device upside down and hold down the orange button for at least 15 seconds. This will reset your Ring Doorbell back to its factory default settings. Once you’ve completed this step, you can now sell your device or set it up again if you’ve been experiencing problems with it.

If you want to remove your Ring Doorbell completely from your account, grab your phone or device and click on the menu on the side. From there, go down to “devices” and select your doorbell. Click on the gear icon at the top and then hit “remove device.” The app will ask you to confirm, and once you do, the doorbell will be removed from your account.

To reattach your Ring Doorbell, align it with the mounting bracket and push down until it locks into place. Finally, tighten the screws back up, and you’re finished.

By following these simple steps, you can reset your Ring Doorbell and get back to using it with ease.


Is there a way to factory reset a ring doorbell?
Undo the security screws and remove your doorbell from its bracket.Press and hold the orange setup button on the back of the device for 10 seconds.The light on the front of the doorbell will flash for several minutes, when the light turns off the reset is complete.
How do I reconnect my ring doorbell after reset?
Open the Ring app.Tap the top menu (≡).Tap Devices and select the doorbell or security camera you need to reconnect to wifi.Tap Device Health.Tap on Reconnect to Wifi or Change Wifi Network.
Can you reset a ring doorbell without the app?
For wired Ring Video Doorbell and Security Camera devices, you can turn off the power at the consumer unit, wait a few seconds, then turn it back on. The device will reboot automatically when power is restored.