Ethernet cables are commonly used to connect devices to the internet and other networks. However, sometimes they can get stuck in the port, making it difficult to remove them. In this article, we will provide you with a step-by-step guide on how to unplug an ethernet cable that is stuck in the port.
Firstly, it is important to understand that removing a stuck ethernet cable requires patience and careful handling to avoid damaging the port or the cable. There are two scenarios where the cable might get stuck; the tab breaks, or the notch gets lodged in place. Regardless of the situation, the process of removing the cable is essentially the same.
To remove a stuck ethernet cable, you will need a screwdriver. It is recommended to use a thin screwdriver like a glasses screwdriver to avoid damaging the port. If the cable is stuck in the port, you will only have access to the little piece that allows you to push it down without touching the plastic piece.
Next, pull the piece back to give you more access and carefully slide the screwdriver along the tab or notch. As you slide it forward, it should push down, allowing you to retrieve the cable. If you still cannot retrieve it, you may need to slide the screwdriver a bit further and push down harder. However, be careful not to touch the interior of the port to avoid damaging it.
When you push down on the tab and pull it back, the cable should come out easily. Remember to be patient and avoid poking around carelessly with the screwdriver as this could damage the port.
In conclusion, removing a stuck ethernet cable requires patience and careful handling. If you follow the steps above, you should be able to remove the cable without damaging the port or the cable. We hope this guide has been helpful to you.