As our lives become increasingly dependent on technology, nothing is more frustrating than a slow internet connection. Recently, a tech-savvy individual ran into a problem with their internet speed. They had two internet cables running from the same source, but only one was running at gigabit speed, while the other was capped at a hundred megabit. This seemed odd since the ports on the switch that connected these cables were all gigabit.
After some investigation, the problem was found: two of the conductors in the cable that was running at a hundred megabit had fallen in, rendering it incapable of transmitting and receiving data at gigabit speed. It was discovered that the user had been rough with the cable, pulling it while it was still plugged in.
To fix the issue, the tech-savvy individual had to cut the old RJ footing off and re-crimp it. They had to make sure that all the conductors were pushed right to the end and that the jacket was correctly pinched. Once everything was fixed, they could finally test the cable.
The moral of the story is to always check your cables before running them. Ensure that they are terminated properly and that the conductors are pushed right to the end. It’s a small task that can save you a significant amount of time in the long run.
In conclusion, the speed of your internet connection can be affected by something as small as a misplaced conductor in your cable. So, it’s always best to be careful and attentive when handling your cables, as this can make a world of difference in the quality and speed of your internet connection.