Getting a coax cable on an RG6 connector can be a daunting task, especially if you don’t have special tools for it. However, with a little effort and patience, you can do it at home without destroying anything. In this post, we’ll guide you through the process of unscrewing a cable cord without using any professional tools.
Firstly, it’s important to know the difference between an RG6 and an RG59 as the latter is likely to be the cable type you are dealing with. If you’re not sure, watch a video explaining the differences between the two. Once you have your coax cable, you need to strip it to expose the wires.
Start by cutting half an inch of the cable, followed by a quarter of an inch. This will expose the wires the way you need them. Next, push the cable in and cut through the mesh and the white foam. Take off the insulator, but be careful not to damage the wires. Clean it up a bit, and your wire is ready.
The copper should stick out about a quarter of an inch. You can push the wires back or cut them off; it doesn’t matter. Make sure to start with a clean cut in the beginning and be fairly accurate when you’re doing this.
To connect the cable to the compression fitting, wiggle it in until there’s a hole in there that you can get around. There’s a metal tube in there that will go in between the foil and the rubber outer sleeve. You can shove it on with tools that flare it out, but it’s not necessary.
Once you’ve connected the fitting, use a crimping tool to secure the cable. While you can purchase these tools, there is another option where you can buy twist-on connectors. These are available at most stores, including Walmart.
To use the crimping tool, put the copper part in the little hole and select the gauge. Pull the lever to watch the blue fitting slip right inside. And that’s it! Your cable cord is now unscrewed and ready to use.
In conclusion, unscrewing cable cord can seem like a daunting task, but with a little patience and effort, you can do it at home without any professional tools. Remember to start with a clean cut, be accurate, and use a crimping tool to secure the cable. With these steps, you’ll be able to unscrew your cable cord like a pro!