If you have recently purchased the Oculus Quest 2 Elite Strap with Battery and are wondering how to install it, you have come to the right place. In this guide, we will provide you with a step-by-step process on how to put on the Elite Strap.
Firstly, you need to remove the facial interface by gently popping it off. Next, remove the fabric strap by unvelcroing it and sliding it out. It’s crucial to work from the back towards the front to pop the sides off. You may require some leverage to do so, and we recommend using your knee for support. Once the fabric strap is removed, you can proceed with installing the Elite Strap.
Extend the straps all the way out as far as they will go; this makes it easier for installation. Align it from the forward-facing position and snap it in as you go back towards the back of that headset strap. Once it’s snapped in place, you can loop back in the fabric portion of the strap. After that, insert the facial interface and charge up the Elite Strap itself. Finally, plug in the strap into the headset, and you’re good to go.
It is a straightforward process, and you only need to take your time when doing it. Once completed, you will get the added benefits of extended battery life, and there is a charging port to recharge the strap. However, it’s worth mentioning that it does not work with the Oculus Link cable at this time.
If you have any questions or concerns, feel free to leave them in the comments section below. We hope this guide has been helpful to you. Don’t forget to give this article a thumbs up and share it with your friends who might find it useful.