If you have recently purchased Sennheiser RS 120 wireless headphones and are looking for a guide to connect them to your TV, you have come to the right place. In this article, we will help you connect your headphones to your TV, step by step.
Firstly, it is essential to charge the batteries before you start using the headphones. Rechargeable batteries are only at about 25% when you unpack them, so charge them for at least five hours or best overnight before you start using them.
Once the batteries are fully charged, gently twist the earpads to remove them and insert the batteries in the right direction. Next, connect the power cable to a wall outlet to charge the headphones by placing them on top of the transmitter. The red light indicates that the headphones are now charging.
Assuming your batteries are fully charged, connect the headphones output to your RS 120. Turn on the TV and increase the television’s volume. Check your TV’s settings menu to see if you find an independent volume control for the headphones output in there. With the RS 120, you have about 100 meters or 300 feet of range. However, if you leave the room where the transmitter is and have a thick brick wall in between, it may interfere with your reception.
When you use your TV’s headphones output, it turns off your television’s loudspeakers in most cases. Here’s a solution for that. At the back of the TV, you can use a scart output. You could use a scart to RCA adapter followed by the RCA 2 audio jack adapter. It is also an option to purchase a scart – audio jack adapter to connect the transmitter directly to the scart output on your TV. But, if you’re going to get a scart adapter, make sure you tell the retailer what you want to connect with it.
Now that you’ve connected sound, turn on the TV, and check the transmitter’s green light, which indicates if an audio signal is present. If the light doesn’t turn on or turns off shortly after lighting up, it means that it’s not receiving sound or not enough volume. Ensure that you’ve connected to the right output on your TV. If you’re sure you’ve connected to the right output, make sure that your TV’s volume is also turned up to about 90%. You might have to check your TV’s audio settings menu for that.
Once you’ve got sound coming from your TV to your transmitter, and the green light is lit, you now need to tune the headphones to the frequency of the transmitter. When you turn the headphones on, you will likely hear static noise. Turn the tuning dial until you can hear the TV’s sound loud and clear.
In conclusion, these are the steps to connect your Sennheiser RS 120 headphones to your TV. You can download the instructions manual in the link below or go to Sennheiser’s website. Enjoy watching your favorite shows and movies in peace with your new headphones!