How to Amplify Your TV Antenna Signal for Multiple Televisions

10 ways to improve OTA antenna reception Adjust The Position. ... Switch To An Outdoor Or Attic Antenna. ... Keep The Cable Away From Power Cords. ... Upgrade Your Cable Splitters. ... Install An Antenna Rotator.

When connecting your TV antenna to more than one television in your home, the conventional wisdom is to use a splitter. These devices allow you to connect multiple televisions to your TV antenna, splitting and distributing the signal throughout your home. However, sometimes splitting up your TV signal might result in pixelation or picture disruption on any channels.

If you’re having trouble with your TV signal when using a splitter to connect multiple TVs to your TV antenna, you might have to step it up to a distribution amplifier. While TV signal splitters are handy devices when splitting the signal up two ways, once you start splitting the signal up three or four ways or even eight ways, you may run into problems. Each time you split a signal, you’re essentially cutting the signal in half, which means that each television you add into the system gets less and less signal. This causes reception problems and picture breakup.

To stop signal disruption, you need to use some sort of amplified splitter or distribution amplifier. If you’re going to connect three or more TVs into a house, you want to use a distribution amplifier. This is a device that inserts eight decibels of power back into each port, sending an even stronger signal to each television.

One such amplifier is the Channel Master model, a high-quality device that is well-built and sturdy. It comes with an amplifier, a power adapter, a piece of coax cable, and instructions. To install the amplifier, you need to connect your coax cable to the RF port on your power adapter. This cable is going to carry the voltage needed to your amplifier to make it work, and you’re going to connect it to the power-in port.

Once you have your amplifier installed, you can connect all of the coax cables for the TVs in your home. The amplifier has one port for your antenna input and four ports for your TV outputs. Simply plug in the amplifier and check the signal on your TVs. If you’re getting adequate signal levels on all your TVs, then you’re good to go.

In summary, if you’re going to connect two or more TVs to your TV antenna, you want to make sure that all the televisions are getting an adequate amount of signal. To do that, you want to use some kind of amplified splitter or distribution amplifier, and the Channel Master model is definitely up for the task.


Do TV antenna amplifiers really work?
TV aerial amplifiers and signal boosters do work. They can help overcome signal losses because of cable resistance and because of the splitting of signals to multiple TVs. However, they won't miraculously convert a poor or weak TV signal into a good, reliable signal. When used right, they can fix your signal issues.
Do I need an amplifier for my TV antenna?
TV antenna boosters pick up frequencies that TV signals are broadcast on (VHF and/or UHF), but if other radio waves are broadcast on or near those VHF or UHF frequencies, the antenna will also enhance those signals. If signals are low and don't produce a high-quality picture, it's time to try a booster.