If you have a CCTV DVR but no hardwired LAN connection, you might be left scratching your head as to how to connect it to your wireless router or access point. Most CCTV DVRs come with only a wired LAN port, and hardly any of them have built-in WiFi. So, what do you do if you need a WiFi connection for your DVR? A wireless bridge might be the solution you need.
A wireless bridge can connect your DVR to a wireless access point that is connected to your router. It’s a last resort option if you can’t run a wire for an internet connection to your DVR. In this article, we’ll show you how to set up your DVR with a wireless access point using a wireless bridge.
Firstly, you need to connect your security cameras to your surveillance DVR using coax cable. After that, connect your DVR to your wireless bridge using a Cat5e cable. Your wireless bridge should be configured as a wireless bridge for this application and connected to your wireless access point. You can use any wireless access point and router, such as Linksys Cisco router, for your setup. Make sure to configure port forwarding on your router properly so that you can access your security cameras remotely over the internet.
However, you should keep in mind that video streaming uses a lot of bandwidth and requires reliability. Wireless connections tend to have issues with interference from other wireless devices, network connections going up and down, and speed varying. This is why DVRs come with only a wired connection because they are meant to be set up that way. If you can run a wire, it’s highly recommended that you do so.
In conclusion, a wireless bridge can help you connect your DVR to your router wirelessly when you don’t have a hardwired LAN connection. However, it’s important to keep in mind the downsides of wireless connections, such as decreased reliability and bandwidth issues. If you need more information on how to set up a wireless bridge for your security camera DVR, you can head to cctvcamerapros.com/wirelessDVR.